Niagara Cutter 86186 Carbide Ball Nose End Mill, Inch, Uncoated (Bright) Finish, Roughing and Finish

Welcome to this site, today I would like to introduce Niagara Cutter 86186 Carbide Ball Nose End Mill, Inch, Uncoated (Bright) Finish, Roughing and Finish best buy in US. There are many readers are searching the best review Niagara Cutter 86186 Carbide Ball Nose End Mill, Inch, Uncoated (Bright) Finish, Roughing and Finish before they purchase one. I think its a good step to get the best choice. You can see from its description and features to know that this item has good quality I will provide interesting information for you, you can get a Niagara Cutter 86186 Carbide Ball Nose End Mill, Inch, Uncoated (Bright) Finish, Roughing and Finish at a very cheap price especially for This day. But before you continue reading, please see reviews about Niagara Cutter 86186 Carbide Ball Nose End Mill, Inch, Uncoated (Bright) Finish, Roughing and Finish below

Features :

• Center-cutting design allows the end mill to plunge into material like a drill bit while also performing conventional surface milling.
• Two flutes offer better chip-carrying capacity than end mills with more flutes, enhancing the tool's ability to remove material.
• Uncoated (bright) tools have no additional surface treatment or coating for general-purpose applications.
• Carbide can run at higher speeds than high-speed steel.

Description

The Niagara Cutter CB230 uncoated carbide ball nose end mill provides the better chip-carrying capacity and increased support of two flutes and a 30-degree helix angle for general-purpose machining on a range of materials. The tools ball nose creates contoured surfaces where sharp corners are not required, and the center-cutting design has cutting teeth at the end of the tool, so it can be fed into the workpiece like a drill bit. The end mills two flutes have better chip-carrying capacity than more flutes while offering additional support when the tool goes deep into the material in applications with a high depth of cut. The 30-degree helix angle supports general-purpose applications. It balances lower angles strong cutting edge for difficult-to-machine materials with higher angles increased cutting action, making it suitable for basic milling in a variety of materials, from aluminum and plastic to steel and cast iron. With no coating or surface treatment, the tool features just the base (or substrate) material for a range of general-purpose applications. It can provide an economical alternative to higher-priced coatings. The carbide substrate is harder than high-speed or cobalt steel, making it more wear resistant at high speeds and providing longer tool life. Cutting diameter tolerance is +0. 000 to -0. 002. The round shank accommodates a variety of holders. End mills are designed to remove material and create three-dimensional shapes or profiles. They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter.

Similar

• Niagara Cutter 55803 Carbide Square Nose End Mill, Inch, TiAlN Finish. 125" Cutting Diameter, 0. 125" Shank Diameter.
• Niagara Cutter 85450 Carbide Square Nose End Mill, Inch, Uncoated (Bright) Finish. 250" Cutting Diameter, 0.

Find out more